Step-by-Step Guide to Using the Aleve Back Device

First, ensure the device is fully charged. Check the indicator light; a solid light signifies a full charge.

Preparing the Device

Select the appropriate intensity level. Begin with the lowest setting and gradually increase as tolerated. Apply the gel pad to the affected area of your back. Ensure the pad adheres securely to clean, dry skin. Carefully attach the device to the gel pad, making sure it clicks into place.

Using the Device

Once attached, press the power button. The device will begin emitting heat and/or TENS pulses.

    Adjust the intensity using the control buttons until you find a comfortable level of heat and/or stimulation. Use the device for the recommended duration, typically 20-30 minutes. Consult the user manual for specifics. During use, monitor your skin for any signs of irritation or discomfort. If irritation occurs, immediately remove the device and contact your healthcare provider.

Post-Treatment

After use, gently remove the device and carefully peel off the gel pad. Dispose of the used gel pad properly. Clean the device with a soft, damp cloth. Allow to air dry completely before storing. Store the device in a cool, dry place, away from direct sunlight and moisture.

Troubleshooting

If the device malfunctions, refer to the troubleshooting section in the user manual or contact customer support.

Safety Precautions

    Do not use the device while sleeping. Do not use the device near water. Do not use the device if you have a pacemaker or other implanted medical device. Consult your doctor before using the device if you are pregnant, have a medical condition, or are taking medication.